Intellitouch programming manual

intellitouch® control system for pool and spa important safety instructions read and follow all instructions save these instructions user’s guide. iii IntelliFlo VS Installation and User’s Guide IMPORTANT SAFETY PRECAUTIONS (continued) Water temperature in excess of ° F (° C) may be hazardous to your health.  · Instuctions on delays for valves if needed are covered on P of the Intellitouch manual, which also states that Heaters manufactured by Pentair Water Pool and Spa do not require this cool-down period and do not need the delay to be set up.

This session of Pool School by Presidential Pools, Spas Patio Service Manager, Bill Watson, explains how to program the Pentair Easytouch Automation Panel. This manual describes the how to set up and use the ScreenLogic2 ® Control System, including how to configure your IntelliTouch ® Control System using the Configurator utility, and how to use the ScreenLogic system program to control basic everyday pool and spa operations to advanced setup functions that only need to be performed once. 8. Close the IntelliTouch front panel and secure it with the two retaining screws. 9. Close the IntelliTouch Load Center front door. Fasten the two spring latches. Switch the power on to the IntelliTouch Load Center. Proceed to "Setting up MobileTouch and IntelliTouch" on page 3.

This manual describes the how to set up and use IntelliTouch ScreenLogic, including how to configure your IntelliTouch system using the Configurator utility, and how to use the ScreenLogic program to control basic everyday pool and spa operations to advanced setup functions that only need to be performed once. IntelliTouch Pool and Spa Control System User’s Guide vi In this User’s Guide This manual describes the how to operate the IntelliTouch system to control pool pumps, heaters, spa lights, and other functions. Described are basic everyday operations that can be easily automated, to the advanced setup functions that only need to be performed once. After connecting the Transceiver cable to the IntelliTouch load center (see page 8), the system is ready to setup MobileTouch controller. To manually setup the MobileTouch controller: 1. On the IntelliTouch Outdoor Control Panel, press the Reset button (see below). 2. First Time MobileTouch install: The three red System Control LEDs will be lit.